Fiber Optic Center will be at Photonics West - Schedule your meeting with a member of the FOC team now

INTERCONNECT: Tips

SC Connectors Key Features

Key Features of SC Connectors include: Durability for frequent use Low insertion loss (<0.5 dB) for signal integrity Stable connections with a push-pull mechanism Broad compatibility across various equipment and applications Although older, SC Connectors...
Read More

SC Connector Design Solutions and Benefits for Today’s Applications

When considering newer, smaller form factor connectors, it is good to understand the evolution. SC Connectors, also known as standard, square, subscriber, or Sam Charlie Connectors, were developed by NTT (Nippon Telegraph and Telephone) under the name...
Read More

LC Connectors Latching Mechanism Considerations

LC Connectors are most often used in pairs, clipped together for use with duplex tight-buffered fiber cable in both single-mode and multimode applications. Another common configuration is the unibody duplex LC design for round duplex loose tube cable. While the...
Read More

SC Connector Materials and Costs

Manufactured mostly from injection-molded plastic, SC Connectors are less expensive to produce than metal counterparts like FC and ST. They are available in simplex or duplex configurations and can be either PC or APC. The SC was specifically designed to improve upon...
Read More

LC Connectors Smaller Footprint Make Them Ideal for High-Density Applications

The ‘smaller footprint’ of LC Connectors makes them ideal for high-density applications like data centers, SFP and SFP+ transceivers, Local Area Networks (LAN) and enterprise networks, making them the most commonly used connectors today.  LC Connectors are...
Read More

Implementing a Cross-Sectioning Capability IN-HOUSE

When you implement a cross-sectioning capability IN-HOUSE, this enables you to conduct routine audits and rapid failure analysis. Implementing a cross-sectioning capability in-house, in your own testing environment We can help you set up the equipment, then ...
Read More

Available Supply of Specialty Connectors Has a Positive Impact on Those Considering Using Non-standard Fiber Sizes

Fiber Optic Center, Inc. (FOC), has stock on the shelf of SMA connectors in over 40 hole sizes from 127 to 2645 um, in volumes of as little as 10 to over 20,000 pieces, depending on design and hole size. On any given day, these can include: 144, 150, 172, 201, 205,...
Read More

Notes from Fiber Optic Connector Cross Sectioning Example

Observations: There is a substantial gap between the end of the stripped buffer area to the point of breakage (just inside the internal chamfer of the ceramic ferrule). Also evident is the shrinkage of epoxy which is quite apparent against the chamfer. It ...
Read More

APC Ferrules Angled Surfaces Oriented in a Specific Location Relative to the Connector Key

With APC ferrules, we have an angled surface that MUST be oriented in a specific location relative to the connector key (if not, then two angled connectors would never mate together when connected). Any rotational deviation from this angle-to-key orientation is known...
Read More

Fiber Optic Connector Cross Sectioning Example From “Connector B” Notes

From Fiber Optic Connector Cross Sectioning and Analysis observations from “Connector B” notes Observations:  This connector has (1) distinctive fiber fracture at the beginning of the ceramic internal chamfer (photo B.2). I did notice more than usual...
Read More